The fenders mount to the dock fascia (perimeter) board using two powder-coated aluminum sail tracks and stainless steel screws. The system is designed to install over most existing dock corner rub rails. Ideally the fascia board is 2×8 or larger. It is possible to mount to a 2×6 but it is a tight fit.

Our fenders run $75/foot installed or $65/foot self installed. The miter cut and sewn outside corners run $400 each installed or $360 each for self install.

Dock Armor Fenders can be installed on floating or fixed docks that have a 2x8 or larger fascia board. Installation on a 2x6 fascia board is possible in many cases. Some docks can be modified to accept our fenders by simply installing a 2×8 in the area where you need fenders. We always recommend sending photos of your dock before ordering so we can confirm compatibility with your dock.

Yes. Dock Armor Fenders are backed by a 5-year limited warranty.

Simply send us photos of your dock, the approximate length you would like protected, and your shipping address. We'll review your project and provide a recommendation and quote.

In most cases, no. Dock Armor Fenders are designed to install over most common dock rub rails.

Dock Armor Fenders are designed for long-term marine use. The materials are selected to withstand sun exposure, saltwater environments, and daily contact with boats. They are installed on high traffic fuel docks in both the United States and Australia.

Yes. Dock Armor Fenders are used in both freshwater and saltwater marinas. The hardware is corrosion-resistant and designed for harsh marine environments.

Standard lengths are 2', 3', 6', and 7'. Custom layouts can be created by combining different lengths. We also have miter cut and sewn outside corners. The fenders are 8’ high and extend of the dock 7”

No. While many customers install them end-to-end, the fenders can also be spaced apart to reduce costs while still providing excellent protection.

Spacing depends on the boat and dock layout, but gaps of up to 24 inches are common. We can help determine the best spacing for your application.

Yes. We offer miter cut and sewn 90-degree outside corner sections designed to protect dock corners where impacts are most likely to occur.

No. The marine carpet is non-abrasive when properly maintained. It is designed to protect your boat's finish while providing cushioning during docking. As with any fender system, regular rinsing is important to remove accumulated salt, sand, dirt, and other debris. Allowing abrasive contaminants or salt crystals to build up in the carpet fibers may increase the risk of surface marking. Keeping the fenders clean will help ensure maximum protection for your boat's paint and gelcoat.

Yes. Many customers choose the self-install option. Installation typically requires basic tools such as a tape measure, drill, and an impact driver.

Yes. Professional installation is available in select service areas. We are continually building our dealer network.

At this time we are only offering dark grey.

Very little. Periodic rinsing and occasional cleaning with a scrub brush and mild soap and water will keep the fenders looking and performing their best.

Yes. Dock Armor Fenders help reduce damage to both boats and docks by absorbing impact and minimizing direct contact.

Yes, provided the dock has a suitable fascia board or mounting surface.

Yes. Dock Armor Fenders are commonly used on private slips, marina docks, fuel docks, yacht club docks, and commercial waterfront facilities.

Every dock is different. Send us a few photos and measurements, and we'll review your dock to determine compatibility and provide recommendations.

Call or text Lowell at 858-344-1011 or use the contact form to discuss your project. We're happy to help determine the best solution for your dock and boat.